Overflowing toilet: stop the water first
When a toilet is about to overflow, the fastest fix is at the tank. Lift the lid and hold the rubber flapper closed, or reach behind the bowl and turn the shutoff valve clockwise until it stops. Do not flush again.
Then put towels around the base, switch off any outlet that is near the water and call. We handle overflowing and leaking toilets at night, on weekends and on holidays, and same-day visits are available when we have an opening. If the water in the bowl is dark and smells of sewage, the problem may be in the drain line and not the toilet, which is covered on our drain cleaning page.
What is going wrong with the toilet
Most toilet problems fall into four groups. A running toilet usually has a worn flapper, a misadjusted fill valve or a chain that is too tight. A toilet that rocks or leaks at the floor needs a new wax ring or a repaired flange. A toilet that clogs often has a partial blockage in the trap or a weak flush. A toilet that sweats or drips from the tank has a loose bolt or a cracked tank.
| Symptom | Likely cause | Usual fix |
|---|---|---|
| Water runs all day | Worn flapper or fill valve | Replace the part |
| Puddle at the base | Failed wax ring or loose closet bolts | Reset the toilet with a new ring |
| Toilet rocks | Flange damaged or floor soft | Repair the flange, check the subfloor |
| Slow or weak flush | Clogged rim jets or partial trap clog | Clear the passages, adjust fill |
| Repeated clogs | Drain line problem | Camera the line |
Under CALGreen standards, toilets in new California installations use 1.28 gallons per flush or less, so a replacement may flush differently from an older unit.
Repair or replace the toilet
A toilet with a worn part is cheap to repair. One with a cracked bowl, a damaged tank or a poor flush that no adjustment improves is better replaced. A toilet that has been rebuilt several times is also a candidate, because each repair buys less time.
When we replace one, we set it on a new wax ring or an equivalent seal, connect it to a new supply line and check for leaks. If a repair reveals a damaged flange or a soft floor, we explain it before going further. For a broader remodel, the plumbing installation page covers fixtures and new lines.
Toilet running or leaking?
Call (626) 898-6169. We repair and replace toilets day or night and book same-day when available.
Hard water and old flanges in Temple City toilets
Golden State Water's South San Gabriel system reported an average hardness of about 240 mg/L in 2025, about 14 grains per gallon. Mineral deposits collect on fill valves, flappers and rim jets, and a toilet that was working fine a few years ago can begin to run or flush weakly.
In houses from the 1950s, which make up 30.6 percent of Temple City's homes, the closet flange under the toilet is often cast iron or an old plastic that has cracked or rusted. If the toilet rocks after a reset, the flange is worth checking before a new ring goes on.
A routine check of the tank's inner parts every few years, with a drop of dye in the tank to test for silent leaks, is a cheap habit that prevents a surprise water bill.
What decides the price of a toilet repair
Water damage from an overflow is often covered by homeowner insurance, though the toilet itself is not. Want your real number? Call (626) 898-6169. The plumber states the price before work starts.
Questions we get asked
Yes. The line at (626) 898-6169 is open 24/7. If a toilet is overflowing or leaking at the base, call any hour and we will book a same-day visit when we have an opening.
Start with a flange plunger and steady pressure. A toilet auger reaches deeper clogs. Avoid chemical drain cleaners in a toilet, because they sit in the bowl and can splash when a plumber opens it.
A flapper that no longer seals is the most common reason, followed by a fill valve set too high. Dye in the tank will show whether the water is leaking into the bowl.
It can be. A rocking toilet can break the wax seal and leak, and the leak can rot the subfloor. Have it checked before the floor is damaged.
Yes. We install new toilets, connect supply lines and test the seal. If the old flange or floor is damaged, we explain that before we set the new one.
